Metrohm tiamo 2.4 Manual - Manual (Page 558)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
542 ￭￭￭￭￭￭￭￭
tiamo 2.4
.LP.CAx Calculated value × (1 - 3) for the last measuring point
in the measuring point list
.LP.ERC ERC for the last measuring point in the measuring
point list
.LP.EXx External value × (1 - 3) for the last measuring point in
the measuring point list
.LP.MEA Measured value for the last measuring point in the
unit of the measured value in the measuring point list
.LP.TEM Temperature for the last measuring point in the mea-
suring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.LP.VOL Volume for the last measuring point in the measuring
point list in mL
.MA.MEA Maximum measured value in the unit of the mea-
sured value
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is
reached
.MA.VOL Volume at maximum measured value in mL
.MI.MEA Minimum measured value in the unit of the measured
value
.MI.TEM Temperature at minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MI.VOL Volume at minimum measured value in mL
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list
.SME Start measured value (measured value after process-
ing the start conditions) in the unit of the measured
value
.STE Start temperature (temperature after processing the
start conditions) in °C
.STY Type of stop with which the command was stopped:
1 = normal; 0 = manual or after error