Metrohm tiamo 2.4 Manual - Manual (Page 1501)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
tiamo 2.4
￭￭￭￭￭￭￭￭ 1485
815 Robotic USB Sample Processor XL, 855 Robotic Titrosampler, 864
Robotic Balance Sample Processor
Selection
196.0 mm
Default value 196.0 mm
Swing Head
This parameter is only shown when a swing head is mounted on the
tower.
Serial number
Shows the serial number of the swing head.
Swing position
Lift position valid for all 4 external positions, at which the swing head
turns to the external positions.
Input range 0 - 235 mm
Default value 0 mm
Rinse position
Rinse position valid for all 4 external positions.
Input range 0 - 235 mm
Default value 0 mm
[Configuration]
Opens the dialog window Configuration (see Chapter 7.7.8, page
1519) in which the properties of the robotic arm can be editet.
Table for external positions
The properties for the 4 possible external positions for the swing head
mounted on the tower are shown in the table. The table is not editable
directly.
External position
Number of the external position.
Angle [°]
Swing angle for external position.
Work position [mm]
Work position for external position.