Metrohm tiamo 2.4 Manual - Manual (Page 1310)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1294 ￭￭￭￭￭￭￭￭
tiamo 2.4
5.6.10.6.2 SEQUENCE - Properties
Dialog window: Method ▶ SEQUENCE ▶ Properties... ▶ SEQUENCE - Sequence #
Command name
Name of the command.
Entry 25 characters
There is no limit to the number of commands that can be added to a
SEQUENCE command; these are displayed in the command table. It con-
tains information regarding Command type and Command name. The
table itself cannot be edited. The individual lines of the table can be edited
with a context-sensitive menu.
Moves the selected command up (changes the sequence).
Moves the selected command down (changes the sequence).
[New]
Opens the New command dialog window for the selection of the
desired command that is to be inserted at the end of the table (see Chap-
ter 5.2.4.2.1, page 410).
[Properties]
Opens the dialog window of the selected command (see Chapter
5.2.4.2.1, page 410).
[Delete]
Deletes the selected command.
Copy
Cut This context-sensitive menu item is used to delete the commands selected in the
table and copy them to the clipboard.
Insert This context-sensitive menu item is used to insert the commands that were cop-
ied to the clipboard at the end of the table.