Metrohm tiamo 2.4 Manual - Manual (Page 1117)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1101
5.6.5.4 CAL Cond
5.6.5.4.1 CAL Cond - Overview
Dialog window: Method ▶ CAL Cond ▶ Properties... ▶ CAL Cond - 'Command
name'
Command for Conductivity standards measurements for the determi-
nation of the cell constants of conductivity sensors.
Devices
This command can be executed with the following devices:
Conductometer: 712, 856
Appearance
The command has the following appearance:
Parameters
The parameters for the command CAL Cond are configured on the fol-
lowing 3 tabs:
￭ General/Hardware
Parameters for devices, sensors and stirrers.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Conductivity standard
Defining the values or the type of the input for calibration with one
standard.
Command variables
The following command variables are generated in the method run by the
command CAL Cond and can be used in formulas under the designation
'Command name.Variable designation':
Identifica-
tion Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.CLC Cell constants determined by calibration for the sensor
used in the command with conductivity sensors (only
MEAS Cond and CAL Cond)