Metrohm tiamo 2.4 Manual - Manual (Page 56)

2.4 Formula editor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
40 ￭￭￭￭￭￭￭￭
tiamo 2.4
Identifica-
tion Description Commands
.DBL Total duration for the processing
of the command in s DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS, CAL
Cond, CAL
MEAS, CAL Spec,
STDADD, DOS,
ELT MEAS
.DEF Default value which is defined in
the configuration for an IO port ANALOG OUT,
DIGITAL OUT
.DRI Current and/or last drift for drift
correction in µL/min SET, KFT, KFC,
BRC
.DSC Time for processing all start con-
ditions in s DET, MET, SET,
KFT, STAT
.DTI Time in s for drift correction (time
from the start of the titration to
the end of the command) SET, KFT, KFC,
BRC
.EGF Last measured gas flow rate
(measured value following pro-
cessing of the command) in
mL/min MEAS T/Flow
.EME End measured value (measured
value after processing of the com-
mand) in the unit of the mea-
sured value DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS,
STDADD, DOS,
ELT MEAS
.ENP Electrode zero point for the sen-
sor used for the command
(dimensionless for pH sensor or in
mV for the ISE sensor) and/or
electrode zero point calculated
from the calibration (for STDADD
and CAL LOOP) DET pH, DET U,
MET pH, MET U,
SET pH, SET U,
STAT, MEAS pH,
MEAS U, MEAS
T, MEAS Conc,
STDADD, CAL
LOOP, DOS, ELT
LOOP
.EP{x}.CHA Charge for endpoint x (1 - 9) in
mA·s KFC, BRC