Metrohm tiamo 2.4 Manual - Manual (Page 1302)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1286 ￭￭￭￭￭￭￭￭
tiamo 2.4
5.6.10.3.2 CALL - Properties
Dialog window: Method ▶ CALL ▶ Properties... ▶ CALL - Call #
Command name
Name of the command.
Entry 25 characters
Call table
All the defined calls listed in the table are carried out simultaneously. The
table cannot be edited directly.
NOTE
The CALL command waits for either the end of the tracks called or the
acknowledgement signal of them. If the completion of a track is not to
be waited for, the option Return immediately must be activated in
the corresponding track command (see Chapter 5.6.2.3, page 451).
[New]
Opens the dialog window Call to enter a new call (see Chapter
5.6.10.3.3, page 1286).
NOTE
10 calls can be defined at maximum.
[Properties]
Opens the dialog window Call to edit the call selected in the table (see
Chapter 5.6.10.3.3, page 1286).
[Delete]
Deletes the selected call.
5.6.10.3.3 CALL - Call
Dialog window: Method ▶ CALL ▶ Properties... ▶ [New]
Call text
Text (can be edited to suit) for designating the call that is shown in the
command presentation.
Entry 50 characters
Default value 'empty'