Metrohm tiamo 2.4 Manual - Manual (Page 478)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
462 ￭￭￭￭￭￭￭￭
tiamo 2.4
Identification Description
.LP.MEA Measured value for the last measuring point in the
measuring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point in the mea-
suring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.LP.VOL Volume for the last measuring point in the measuring
point list in mL
.MA.MEA Maximum measured value in the unit of the mea-
sured value
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is
reached
.MA.VOL Volume at maximum measured value in mL
.MI.MEA Minimum measured value in the unit of the measured
value
.MI.TEM Temperature at minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MI.VOL Volume at minimum measured value in mL
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list
.SLO Electrode slope of the sensor used for the command
(in %)
.SME Start measured value (measured value after process-
ing the start conditions) in the unit of the measured
value
.STE Start temperature (temperature after processing the
start conditions) in °C
.STY Type of stop with which the command was stopped:
1 = normal; 0 = manual or after error
.SVA Start volume absolute (volume that was added
according to the start condition "start volume") in mL