Metrohm tiamo 2.4 Manual - Manual (Page 824)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
808 ￭￭￭￭￭￭￭￭
tiamo 2.4
Identification Description
.CYL Cylinder volume of the exchange or dosing unit used
for the command
.DBL Total duration for the processing of the command in
s
.DRI Current and/or last drift for drift correction in µL/min
.DSC Time for processing all start conditions in s
.DTI Time in s for drift correction (time from the start of
the titration to the end of the command)
.EME End measured value (measured value after processing
of the command) in the unit of the measured value
.EP.MEA Measured value for the endpoint in the unit of the
measured value
.EP.MEP Number of endpoints 1 = 1 endpoint, 2 = 2 or
more endpoints, 3 = EP corrected with Auto-
drift, 4 = EP corrected with manual drift
.EP.TEM Temperature for the endpoint in °C
.EP.TIM Time in s until the endpoint is reached
.EP.VOL Volume for the endpoint in mL
.ETE End temperature (temperature after the command
has been processed) in °C
.EVT End volume (total dosed volume at the end of the
command) in mL
.FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
.FP{x}.MEA Measured value for the fixed endpoint × (1 - 9) in mV
.FP{x}.TEM Temperature for the fixed endpoint × (1 - 9) in °C
.FP{x}.TIM Time in s until the fixed endpoint × (1 - 9) is reached
.FP{x}.VOL Volume for the fixed endpoint × (1 - 9) in mL
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start condi-
tions are processed) in °C