Metrohm tiamo 2.4 Manual - Manual (Page 1590)

7.16 RS-232 device
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1574 ￭￭￭￭￭￭￭￭
tiamo 2.4
Timeout
Maximum waiting time for receiving characters. If this time is exceeded,
receiving will be stopped.
Input range 1000 - 9999 ms
Default value 2000 ms
Terminator for send
Terminator for send in hexadecimal code.
Selection \0D | \0D\0A | \0D\0A\0A | \0D\0D\0A
Default value \0D\0A
(\0D = CR, \0A = LF)
Terminator for receiving
Final character for receiving in hexadecimal code.
Selection \0D | \0D\0A | \0D\0A\0A | \0D\0D\0A
Default value \0D\0A
(\0D = CR, \0A = LF)
Code page
Code page used for the data transfer.
Selection Cp437 | Cp850 | Cp852 | ASCII
Default value Cp437
Sending characters separately
on | off (Default value: off)
If this option is enabled each character is sent separately. The delay time is
allowed to run before sending the next character.
Delay time
Delay time until the sending of the next character.
Input range
0 - 9999 ms
Default value 0 ms
[Connect]
Establishes the connection to the RS-232 device. The dialog window
Establish connection appears (see Chapter 7.16.5, page 1576).
[Disconnect]
Disconnects the connection to the RS-232 device (only then the device
can be deleted out of the configuration).