Metrohm tiamo 2.4 Manual - Manual (Page 1063)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1047
Identification Description
.ITE 1) Initial temperature (temperature before start condi-
tions are processed) in °C
.LP.CAx Calculated value x (1 - 3) for the last measuring point
on the measuring point list
.LP.CNT Transmission of the last measuring point in the mea-
suring point list in %
.LP.EXx External value x (1 - 3) for the last measuring point
on the measuring point list
.LP.MEA Measured value for the last measuring point in the
measuring point list in the unit of the measured value
.LP.TEM 1) Temperature for the last measuring point in the mea-
suring point list in °C
.LP.TIM Time in s until the last measuring point in the mea-
suring point list is reached
.LP.TRN Transmission of the last measuring point in the mea-
suring point list in %
.MA{#}.[MEA] Maximum measured value in the unit of the mea-
sured value
.MA{#}.CNT Intensity for maximum measured value in counts
.MA{#}.TEM 1) Temperature for minimum measured value in °C
.MA{#}.TIM Time for the minimum measured value in s
.MA{#}.TRN Transmission for maximum measured value in %
.MI{#}.[MEA] Minimum measured value in the unit of the mea-
sured value
.MI{#}.CNT Intensity for minimum measured value in counts
.MI{#}.TEM 1) Temperature for minimum measured value in °C
.MI{#}.TIM Time for the minimum measured value in s
.MI{#}.TRN Transmission for minimum measured value in %
.MTE Temperature measurement with sensor; (1 = on, 0 =
off)
2)
.NMP Number of measuring points in measuring point list
.STY Type of stop with which the command was stopped:
1 = normal; 0 = manual or after error
1) Command variable is invalid for the Avantes spectrometer