Metrohm tiamo 2.4 Manual - Manual (Page 159)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Workplace
tiamo 2.4
￭￭￭￭￭￭￭￭ 143
Copy automatically into the next determination
Sample size
on | off (Default value: on)
Sample size unit
on | off (Default value: on)
Sample position
on | off (Default value: on)
ID1...ID16
on | off (Default value: on)
3.6.3.9.4 Properties - Process
Tab: Workplace ▶ Run ▶ Single determination ▶ Properties Run window ▶ Prop-
erties - Single determination ▶ Process
Options for the processing of single determinations.
Method selection by assignment ID
on | off (Default value: off)
If this option is enabled, then the selected sample identification will be
used for the method selection. This identification receives the designation
Assignment ID, which can then no longer be changed; if this ID matches
one of the Assignment IDs from the sample assignment table (see Chapter
3.4.1, page 125), then the respective method from this table will be
entered in the field Method.
Selection ID1 | ID2 | ID3 | ID4 | ID5 | ID6 | ID7 | ID8 | ID9 |
ID10 | ID11 | ID12 | ID13 | ID14 | ID15 | ID16
Default value ID1
Request assignment ID
on | off (Default value: off)
If this option is enabled, the Assignment ID will be queried immediately
after the start of the determination.
Autorepeat determination
on | off (Default value: off)
If this option is enabled, then the next determination will be started with
the same method automatically after the completion of a determination.
The determination must be canceled with [Stop] in order to cancel the
automatic repetition.