Metrohm tiamo 2.4 Manual - Manual (Page 862)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
846 ￭￭￭￭￭￭￭￭
tiamo 2.4
Designation Description
.EME End measured value (measured value after processing
of the command) in mV
.EP.CHA Charge for endpoint in mA·s
.EP.DVT Drift for the endpoint in µg/min
.EP.MEA Measured value for the endpoint in mV
.EP.QTY Measured value (water) for the endpoint in µg
.EP.TEM Temperature for the endpoint 1 in °C
.EP.TIM Time in s until the endpoint is reached
.EQT End quantity after processing of the command) in µg
.ETE End temperature (temperature following processing of
the command) in °C
.FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) = Com-
mand has never ended
.FP{x}.DVT Drift for the fixed endpoint × (1…9) in µg/min
.FP{x}.MEA Measured value for the fixed endpoint × (1…9) in mV
.FP{x}.QTY Amount of bromine for the fixed endpoint x (1…9) in
µg
.FP{x}.TEM Temperature for the fixed endpoint x (1…9) in °C
.FP{x}.TIM Time in s until the fixed endpoint × (1…9) is reached
.IME Initial measured value (measured value before start
conditions are processed) in mV
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point
on the measuring point list
.LP.CHA Charge for the last measuring point of the measuring
point list in mA s
.LP.DVT Drift for the last measuring point of the measuring
point list in µg/min
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list