Metrohm tiamo 2.4 Manual - Manual (Page 1224)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1208 ￭￭￭￭￭￭￭￭
tiamo 2.4
Identifi-
cation Description
.CYL Cylinder volume of the exchange or dosing unit used for
the command
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
5.6.6.5.2 PREP - Properties
Dialog window Method ▶ PREP ▶ Properties... ▶ PREP - 'Command name'
Command name
Name of the command.
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Device types | Titrando
Default value Titrando
Dosing device
Dosing device
Selection of the dosing device to be prepared. All the dosing device con-
nections which are possible with the selected device type are displayed.