Metrohm tiamo 2.4 Manual - Manual (Page 1508)

7.4 856 Conductivity Module
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1492 ￭￭￭￭￭￭￭￭
tiamo 2.4
[Update]
Opens the dialog window Load new program version (see Chapter
7.17.6, page 1582).
This button is only displayed with devices that have their own firmware. It
is only active if the device has an old program version not supported by
tiamo and which can be updated by tiamo itself.
Device serial number
Shows the serial number of the device.
Set to work
Shows the date on which the device was automatically added to the
device table.
Data storage under legal control
Indicates whether the balance has its own data storage under legal con-
trol.
Only visible and editable with Sartorius balances
Selection
on | off
Default value off
Remarks
Remarks about the device.
Entry 1000 characters
Default value empty
7.4.3 Properties - Measuring inputs
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Measuring inputs
On the tab Measuring inputs the properties of the measuring inputs
used on the device are displayed. For each measuring input a group of
parameters is displayed.
Intelligent measuring inputs (if present and used) are listed separately and
labeled with the additive iConnect
Measuring input 1/2 (iConnect)
ADC type
Shows the type of analog-digital converter.
Serial number
Shows the serial number of the measuring input interface.