Metrohm tiamo 2.4 Manual - Manual (Page 1203)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1187
Command variables
The following command variables are generated in the method run by the
command DOS U and can be used in formulas under the designation
'Command name.Variable designation':
Identifica-
tion Description
.BLV Blank value of the sensor used for the command (only
for ISE sensors)
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has not ever been started
.CONC Concentration of the solution used for the command
.CYL Cylinder volume of the exchange or dosing unit used
for the command
.DBL Total duration for the processing of the command in s
.EME Final measured value (measured value after processing
of the command) in the unit of the measured value
.ENP Electrode slope of the sensor used for the command (in
mV for ISE sensors)
.ETE End temperature (temperature following processing of
the command) in °C
.EVT End volume (total dosed volume at the end of the com-
mand) in mL
.FIN Command status; 1 = Command has been ended
at least once, 0, invalid (variable not available) =
Command has never been ended
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point
of the measuring point list
.LP.DVT dV/dt for the last measuring point in the measuring
point list (SET, KFT, STAT, DOS) or drift for the last
measuring point in in the measuring point list in µg/min
(KFC)