Metrohm tiamo 2.4 Manual - Manual (Page 1481)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Configuration
tiamo 2.4
￭￭￭￭￭￭￭￭ 1465
Special position
Special position for Lift 1. This additional definable position can be used
e.g. during pipetting so that the tip is just immersed in the sample solu-
tion.
Input range 0 - 235 mm
Tower 2
Defines the lift positions for Tower 2. These apply for all rack positions
except those that are defined as Special beaker.
Work position
Work position for Lift 2. At this lift position the electrodes, stirrer and
buret tips are optimally positioned for work.
Input range 0 - 235 mm
Rinse position
Rinse position for Lift 2. This lift position is used for rinsing the electrodes.
Input range 0 - 235 mm
Shift position
Shift position for Lift 2. Each time that the rack shifts, the lift will move to
this position if it is located at a lower lift position. If the lift is located at a
higher lift position than that defined here, then the shifting will take place
at the current lift position. This means that the shift position must be
selected so that a safe movement across the entire rack is possible at any
time.
Input range 0 - 235 mm
Special position
Special position for Lift 2. This additional definable position can be used
e.g. during pipetting so that the tip is just immersed in the sample solu-
tion.
Input range 0 - 235 mm
6.12.3.4 Properties - Special beaker
Tab: Configuration ▶ Rack data ▶ [Edit] ▶ Properties... ▶ Rack data ▶ Special
beakers
The table shows all the data of all the special beakers of the attached rack
in tabular form. Each special beaker can be assigned to any position on
the rack. The table cannot be edited directly.