Metrohm tiamo 2.4 Manual - Manual (Page 1217)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1201
[Delete]
Deletes the calculated measured value selected in the table.
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be taken over and saved from existing measuring commands (i.e. MEAS)
which can also be displayed in curves under the designation Extern 1…3
and used in formulas as variables 'Command name.EX1…3'-
[New]
Opens the dialog window External measured value # in which the
parameters for the external measured value can be entered (see Chapter
5.6.3.11.2, page 934).
[Properties]
Opens the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.11.2, page 934).
[Delete]
Deletes the external measured value selected in the table.
5.6.6.4 LQH
5.6.6.4.1 LQH - Overview
Dialog window: Method ▶ LQH ▶ Properties... ▶ LQH - 'Command name'
Command for complex dosing tasks with a Dosino dosing device (700
or 800).
Devices
This command can be executed with the following devices equipped with
a Dosino 700/800:
Titrando: 808, 809, 835, 836, 841, 842, 851, 852, 857, 859, 901, 902,
904, 905, 906, 907
Dosing Interface: 846
Conductometer: 856
pH/Ion Meter: 867
Sample Processor: 778, 789, 814, 815, 864, 874
Robotic Titrosampler: 855