Metrohm tiamo 2.4 Manual - Manual (Page 1468)

6.10 Subwindow Global variables
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1452 ￭￭￭￭￭￭￭￭
tiamo 2.4
[Limits]
Opens the dialog window Limits for global variable in which the warn-
ing and action limits can be defined for the global variables. These limits
apply only to the graph; no monitoring takes place during value assign-
ment.
[Delete history]
Deletes the history.
6.10.3.4 History - Limits
Dialog window: Configuration ▶ Global variable ▶ [Edit] ▶ Properties ▶ Global var-
iable - 'Name' ▶ History ▶ [Limit value] ▶ Limits for Global variable - 'Name'
In the dialog window Limits for global variable both warning and
intervention limits can be defined for the values of the global variables. If
you have defined limits then these will be shown in the graph in orange
for warning limits and red for intervention limits. However, whether these
limits are observed is not monitored, i.e. exceeding these limits does not
trigger any action.
Warning limits for global variable
on | off (Default value: off)
If this option is enabled then the values of the global variables will be
shown in orange if these limits are exceeded.
Lower limit
Lower warning limit for global variable.
Input range -1.0 E+99 - 1.0E+99 (max. 10 digits)
Upper limit
Upper warning limit for global variable.
Input range -1.0 E+99 - 1.0E+99 (max. 10 digits)
Intervention limits for global variable
on | off (Default value: off)
If this option is enabled then the values of the global variables will be
shown in red if these limits are exceeded.
Lower limit
Lower warning limit for global variable.
Input range -1.0 E+99 - 1.0E+99 (max. 10 digits)
Upper limit
Upper warning limit for global variable.