Metrohm tiamo 2.4 Manual - Manual (Page 1054)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1038 ￭￭￭￭￭￭￭￭
tiamo 2.4
Appearance
The command has the following appearance:
Parameters
The parameters for the MEAS Ref command are set on the following
two tabs:
￭ General/Hardware
Parameters for instrument.
￭ Measuring parameters
Parameters for setting the measurement procedure.
Command variables
The following command variables are generated by the MEAS Ref com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.DBL Total duration for the processing of the command in s
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command has
never ended
.STY Type of stop with which the command was stopped: 1 =
normal; 0 = manual or after error
5.6.4.12.2 MEAS Ref - General/Hardware
Tab: Method ▶ MEAS Ref ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Entry 25 characters
The general parameters for the instrument are defined on this tab.