LevelOne GTL-2691 - Manual (Page 998)

C HAPTER 31 | Interface Commands
Interface Configuration
– 998 –
Interface Configuration
interface This command configures an interface type and enters interface
configuration mode. Use the no form with a trunk to remove an inactive
interface. Use the no form with a Layer 3 VLAN (normal type) to change it
back to a Layer 2 interface.
S YNTAX
[no] interface interface
interface
ethernet unit/port-list
unit - Stack unit. (Range: 1-8)
port-list - Physical port number or list of port numbers.
Separate nonconsecutive port numbers with a comma and
no spaces; or use a hyphen to designate a range of port
numbers. (Range: 1-26)
port-channel channel-id (Range: 1-32)
vlan vlan-id (Range: 1-4093)
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration
E XAMPLE
To specify port 4, enter the following command:
Console(config)#interface ethernet 1/4
Console(config-if)#
alias This command configures an alias name for the interface. Use the no form
to remove the alias name.
S YNTAX
alias string
no alias
string - A mnemonic name to help you remember what is attached
to this interface. (Range: 1-64 characters)
D EFAULT S ETTING
None