Figure 63: creating static vlans – LevelOne GTL-2691 User Manual
Page 201
C
HAPTER
6
| VLAN Configuration
IEEE 802.1Q VLANs
– 201 –
about this interface type. This parameter must be enabled before you
can assign an IP address to a VLAN (see
Address (IP Version 4)" on page 573
Modify
◆
VLAN ID – ID of configured VLAN (1-4093).
◆
VLAN Name – Name of the VLAN (1 to 32 characters).
◆
Status – Enables or disables the specified VLAN.
◆
L3 Interface – Sets the interface to support Layer 3 configuration, and
reserves memory space required to maintain additional information
about this interface type. This parameter must be enabled before you
can assign an IP address to a VLAN.
Show
◆
VLAN ID – ID of configured VLAN.
◆
VLAN Name – Name of the VLAN.
◆
Status – Operational status of configured VLAN.
◆
L3 Interface – Shows if the interface supports Layer 3 configuration.
W
EB
I
NTERFACE
To create VLAN groups:
1.
Click VLAN, Static.
2.
Select Add from the Action list.
3.
Enter a VLAN ID or range of IDs.
4.
Mark Enabled to configure the VLAN as operational.
5.
Enable the L3 Interface field to specify that a VLAN will be used as a
Layer 3 interface.
6.
Click Apply.
Figure 63: Creating Static VLANs