LevelOne GTL-2691 - Manual (Page 1545)

– 1545 –
50
M
ULTICAST
R
OUTING
C
OMMANDS
Multicast routers can use various kinds of multicast routing protocols to
deliver IP multicast packets across different subnetworks. This router
supports Protocol Independent Multicasting (PIM). (Note that IGMP will be
enabled for any interface that is using multicast routing.)
G ENERAL M ULTICAST R OUTING
This section describes commands used to configure multicast routing
globally on the switch.
IPv4 Commands
ip multicast-routing This command enables IPv4 multicast routing. Use the no form to disable
IP multicast routing.
S YNTAX
[no] ip multicast-routing
D EFAULT S ETTING
Disabled
Table 223: Multicast Routing Commands
Command Group Function
General Multicast Routing Enables IP multicast routing globally; also displays the IP
multicast routing table created from static and dynamic routing
information
Static Multicast Routing Configures static multicast router ports
PIM Multicast Routing Configures global and interface settings for PIM-DM and PIM-SM
Table 224: General Multicast Routing Commands
Command Function Mode
IPv4 Commands
ip multicast-routing Enables IPv4 multicast routing GC
show ip mroute Shows the IPv4 multicast routing table PE
IPv6 Commands
ipv6 multicast-routing Enables IPv6 multicast routing GC
show ipv6 mroute Shows the IPv6 multicast routing table PE