LevelOne GTL-2691 - Manual (Page 868)

C HAPTER 28 | Authentication Commands
RADIUS Client
– 868 –
“authentication login radius tacacs local,” the user name and
password on the RADIUS server is verified first. If the RADIUS server is
not available, then authentication is attempted on the TACACS+ server.
If the TACACS+ server is not available, the local user name and
password is checked.
E XAMPLE
Console(config)#authentication login radius
Console(config)#
R ELATED C OMMANDS
username - for setting the local user names and passwords ( 865 )
RADIUS C LIENT
Remote Authentication Dial-in User Service (RADIUS) is a logon
authentication protocol that uses software running on a central server to
control access to RADIUS-aware devices on the network. An authentication
server contains a database of multiple user name/password pairs with
associated privilege levels for each user or group that require management
access to a switch.
radius-server acct-
port
This command sets the RADIUS server network port for accounting
messages. Use the no form to restore the default.
S YNTAX
radius-server acct-port port-number
no radius-server acct-port
port-number - RADIUS server UDP port used for accounting
messages. (Range: 1-65535)
D EFAULT S ETTING
1813
Table 71: RADIUS Client Commands
Command Function Mode
radius-server acct-port Sets the RADIUS server network port GC
radius-server auth-port Sets the RADIUS server network port GC
radius-server host Specifies the RADIUS server GC
radius-server key Sets the RADIUS encryption key GC
radius-server retransmit Sets the number of retries GC
radius-server timeout Sets the interval between sending authentication
requests
GC
show radius-server Shows the current RADIUS settings PE