Router-id, Router-id 1479 – LevelOne GTL-2691 User Manual
Page 1479
C
HAPTER
49
| IP Routing Commands
Open Shortest Path First (OSPFv2)
– 1479 –
router-id
This command assigns a unique router ID for this device within the
autonomous system for the current OSPF process. Use the no form to use
the default router identification method (i.e., the highest interface
address).
S
YNTAX
router-id ip-address
no router-id
ip-address - Router ID formatted as an IPv4 address.
C
OMMAND
M
ODE
Router Configuration
D
EFAULT
S
ETTING
Highest interface address
C
OMMAND
U
SAGE
◆
This command sets the router ID for the OSPF process specified in the
command.
◆
The router ID must be unique for every router in the autonomous
system. Using the default setting based on the highest interface
address ensures that each router ID is unique. (Note that the router ID
can also be set to 0.0.0.0 or 255.255.255.255).
◆
If this router already has registered neighbors, the new router ID will
be used when the router is rebooted, or manually restarted by entering
the no router ospf followed by the router ospf command.
◆
If the priority values of the routers bidding to be the designated router
or backup designated router for an area are equal, the router with the
highest ID is elected.
E
XAMPLE
Console(config-router)#router-id 10.1.1.1
Console(config-router)#
R
ELATED
C
OMMANDS