LevelOne GTL-2691 - Manual (Page 1152)

C HAPTER 39 | VLAN Commands
Configuring Voice VLANs
– 1152 –
switchport voice
vlan rule
This command selects a method for detecting VoIP traffic on a port. Use
the no form to disable the detection method on the port.
S YNTAX
[no] switchport voice vlan rule {oui | lldp}
oui - Traffic from VoIP devices is detected by the Organizationally
Unique Identifier (OUI) of the source MAC address.
lldp - Uses LLDP to discover VoIP devices attached to the port.
D EFAULT S ETTING
OUI: Enabled
LLDP: Disabled
C OMMAND M ODE
Interface Configuration
C OMMAND U SAGE
◆ When OUI is selected, be sure to configure the MAC address ranges in
the Telephony OUI list (see the voice vlan mac-address command. MAC
address OUI numbers must be configured in the Telephony OUI list so
that the switch recognizes the traffic as being from a VoIP device.
◆ LLDP checks that the “telephone bit” in the system capability TLV is
turned on. See "LLDP Commands" on page 1285 for more information
on LLDP.
E XAMPLE
The following example enables the OUI method on port 1 for detecting
VoIP traffic.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan rule oui
Console(config-if)#
switchport voice
vlan security
This command enables security filtering for VoIP traffic on a port. Use the
no form to disable filtering on a port.
S YNTAX
[no] switchport voice vlan security
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration