LevelOne GTL-2691 - Manual (Page 1480)

C HAPTER 49 | IP Routing Commands
Open Shortest Path First (OSPFv2)
– 1480 –
timers spf This command configures the delay after receiving a topology change and
starting the shortest path first (SPF) calculation, and the hold time
between making two consecutive SPF calculations. Use the no form to
restore the default values.
S YNTAX
timers spf spf-delay spf-holdtime
no timers spf
spf-delay - The delay after receiving a topology change notification
and starting the SPF calculation. (Range: 0-2147483647 seconds)
spf-holdtime - Minimum time between two consecutive SPF
calculations. (Range: 0-2147483647 seconds)
C OMMAND M ODE
Router Configuration
D EFAULT S ETTING
SPF delay: 5 seconds
SPF holdtime: 10 seconds
C OMMAND U SAGE
◆ Setting the SPF holdtime to 0 means that there is no delay between
consecutive calculations.
◆ Using a low value allows the router to switch to a new path faster, but
uses more CPU processing time.
E XAMPLE
Console(config-router)#timers spf 20
Console(config-router)#
clear ip ospf
process
This command clears and restarts the OSPF routing process. Specify the
process ID to clear a particular OSPF process. When no process ID is
specified, this command clears all running OSPF processes.
S YNTAX
clear ip ospf [process-id] process
process-id - Specifies the routing process ID. (Range: 1-65535)
D EFAULT S ETTING
Clears all routing processes.
C OMMAND M ODE
Privileged Exec