LevelOne GTL-2691 - Manual (Page 1251)

C HAPTER 42 | Multicast Filtering Commands
MVR for IPv6
– 1251 –
mvr6 upstream-
source-ip
This command configures the source IPv6 address assigned to all MVR
control packets sent upstream on the specified domain. Use the no form to
restore the default setting.
S YNTAX
mvr6 domain domain-id upstream-source-ip source-ip-address
no mvr6 domain domain-id upstream-source-ip
domain-id - An independent multicast domain. (Range: 1-5)
source-ip-address – The source IPv6 address assigned to all MVR
control packets sent upstream. This parameter must be a full IPv6
address including the network prefix and host address bits.
D EFAULT S ETTING
All MVR reports sent upstream use a null source IP address
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
All IPv6 addresses must be according to RFC 2373 “IPv6 Addressing
Architecture,” using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields. (Note that the IP
address ff02::X is reserved.)
E XAMPLE
Console(config)#mvr6 domain 1 upstream-source-ip 2001:DB8:2222:7223::72
Console(config)#
mvr6 vlan This command specifies the VLAN through which MVR multicast data is
received. Use the no form of this command to restore the default MVR
VLAN.
S YNTAX
mvr6 domain domain-id vlan vlan-id
no mvr6 domain domain-id vlan
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Specifies the VLAN through which MVR multicast data is
received. This is also the VLAN to which all source ports must be
assigned. (Range: 1-4093)
D EFAULT S ETTING
VLAN 1