Sntp poll, Sntp server – LevelOne GTL-2691 User Manual
Page 810
C
HAPTER
24
| System Management Commands
Time
– 810 –
Current Mode: unicast
SNTP Status : Enabled
SNTP Server 137.92.140.80 0.0.0.0 0.0.0.0
Current Server: 137.92.140.80
Console#
R
ELATED
C
OMMANDS
sntp poll
This command sets the interval between sending time requests when the
switch is set to SNTP client mode. Use the no form to restore to the
default.
S
YNTAX
sntp poll seconds
no sntp poll
seconds - Interval between time requests.
(Range: 16-16384 seconds)
D
EFAULT
S
ETTING
16 seconds
C
OMMAND
M
ODE
Global Configuration
E
XAMPLE
Console(config)#sntp poll 60
Console#
R
ELATED
C
OMMANDS
sntp server
This command sets the IP address of the servers to which SNTP time
requests are issued. Use the this command with no arguments to clear all
time servers from the current list. Use the no form to clear all time servers
from the current list, or to clear a specific server.
S
YNTAX
sntp server [ip1 [ip2 [ip3]]]
no sntp server [ip1 [ip2 [ip3]]]
ip - IPv4 or IPv6 address of an time server (NTP or SNTP).
(Range: 1 - 3 addresses)