LevelOne GTL-2691 - Manual (Page 654)

C HAPTER 20 | Unicast Routing
Configuring the Routing Information Protocol
– 654 –
Figure 404: Configuring General Settings for RIP
C LEARING E NTRIES
FROM THE R OUTING
T ABLE
Use the Routing Protocol > RIP > General (Clear Route) page to clear
entries from the routing table based on route type or a specific network
address.
CLI R EFERENCES
◆ "clear ip rip route" on page 1472
C OMMAND U SAGE
◆ Clearing “All” types deletes all routes in the RIP table. To avoid deleting
the entire RIP network, redistribute connected routes using the Routing
Protocol > RIP > Redistribute screen ( page 659 ) to make the RIP
network a connected route. To delete the RIP routes learned from
neighbors, but keep the RIP network intact, clear “RIP” types from the
routing table.
P ARAMETERS
These parameters are displayed:
◆ Clear Route By Type – Clears entries from the RIP routing table based
on the following types:
■
All – Deletes all entries from the routing table.
■
Connected – Deletes all currently connected entries.
■
OSPF – Deletes all entries learned through OSPF.
■
RIP – Deletes all entries learned through the RIP.
■
Static – Deletes all static entries.