Ipv6 access-group, Ipv6 access-group (985) – LevelOne GTL-2691 User Manual
Page 985
C
HAPTER
30
| Access Control Lists
IPv6 ACLs
– 985 –
permit 2009:DB9:2229:5::/64
Console#
R
ELATED
C
OMMANDS
permit, deny (Standard IPv6 ACL) (981)
permit, deny (Extended IPv6 ACL) (982)
ipv6 access-group
This command binds a port to an IPv6 ACL. Use the no form to remove the
port.
S
YNTAX
ipv6 access-group acl-name in [time-range time-range-name]
no ipv6 access-group acl-name in
acl-name – Name of the ACL. (Maximum length: 16 characters)
in – Indicates that this list applies to ingress packets.
time-range-name - Name of the time range.
(Range: 1-30 characters)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Interface Configuration (Ethernet)
C
OMMAND
U
SAGE
◆
A port can only be bound to one ACL.
◆
If a port is already bound to an ACL and you bind it to a different ACL,
the switch will replace the old binding with the new one.
◆
IPv6 ACLs can only be applied to ingress packets.
E
XAMPLE
Console(config)#interface ethernet 1/2
Console(config-if)#ipv6 access-group standard david in
Console(config-if)#
R
ELATED
C
OMMANDS