LevelOne GTL-2691 - Manual (Page 1151)

C HAPTER 39 | VLAN Commands
Configuring Voice VLANs
– 1151 –
C OMMAND U SAGE
When auto is selected, you must select the method to use for detecting
VoIP traffic, either OUI or 802.1ab (LLDP) using the switchport voice vlan
rule command. When OUI is selected, be sure to configure the MAC
address ranges in the Telephony OUI list using the voice vlan mac-address
command.
E XAMPLE
The following example sets port 1 to Voice VLAN auto mode.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan auto
Console(config-if)#
switchport voice
vlan priority
This command specifies a CoS priority for VoIP traffic on a port. Use the no
form to restore the default priority on a port.
S YNTAX
switchport voice vlan priority priority-value
no switchport voice vlan priority
priority-value - The CoS priority value. (Range: 0-6)
D EFAULT S ETTING
6
C OMMAND M ODE
Interface Configuration
C OMMAND U SAGE
Specifies a CoS priority to apply to the port VoIP traffic on the Voice VLAN.
The priority of any received VoIP packet is overwritten with the new
priority when the Voice VLAN feature is active for the port.
E XAMPLE
The following example sets the CoS priority to 5 on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan priority 5
Console(config-if)#