LevelOne GTL-2691 - Manual (Page 831)

C HAPTER 25 | SNMP Commands
General SNMP Commands
– 831 –
E XAMPLE
Console(config)#snmp-server location WC-19
Console(config)#
R ELATED C OMMANDS
snmp-server contact (830)
show snmp This command can be used to check the status of SNMP communications.
D EFAULT S ETTING
None
C OMMAND M ODE
Normal Exec, Privileged Exec
C OMMAND U SAGE
This command provides information on the community access strings,
counter information for SNMP input and output protocol data units, and
whether or not SNMP logging has been enabled with the snmp-server
enable traps command.
E XAMPLE
Console#show snmp
SNMP Agent : Enabled
SNMP Traps :
Authentication : Enabled
Link-up-down : Enabled
SNMP Communities :
1. public, and the access level is read-only
2. private, and the access level is read/write
0 SNMP packets input
0 Bad SNMP version errors
0 Unknown community name
0 Illegal operation for community name supplied
0 Encoding errors
0 Number of requested variables
0 Number of altered variables
0 Get-request PDUs
0 Get-next PDUs
0 Set-request PDUs
0 SNMP packets output
0 Too big errors
0 No such name errors
0 Bad values errors
0 General errors
0 Response PDUs
0 Trap PDUs
SNMP Logging: Disabled
Console#