Ip interface commands, Ipv4 interface, 48 ip i – LevelOne GTL-2691 User Manual
Page 1391: Nterface, Ommands, Table 190: ip interface commands, Table 191: ipv4 interface commands, Ip i
– 1391 –
48
IP I
NTERFACE
C
OMMANDS
An IP Version 4 and Version 6 address may be used for management
access to the switch over the network. Both IPv4 or IPv6 addresses can be
used simultaneously to access the switch. You can manually configure a
specific IPv4 or IPv6 address or direct the switch to obtain an IPv4 address
from a BOOTP or DHCP server when it is powered on. An IPv6 address can
either be manually configured or dynamically generated.
An IPv4 address for this switch is obtained via DHCP by default for VLAN 1.
You may also need to a establish an IPv4 or IPv6 default gateway between
this device and management stations that exist on another network
segment.
IP
V
4 I
NTERFACE
There are no IP addresses assigned to this switch by default. You must
manually configure a new address to manage the switch over your network
or to connect the switch to existing IP subnets. You may also need to a
establish a default gateway between this device and management stations
or other devices that exist on another network segment (if routing is not
enabled).
This section includes commands for configuring IP interfaces, the Address
Resolution Protocol (ARP) and Proxy ARP.
Table 190: IP Interface Commands
Command Group
Function
Configures an IPv4 address for the switch
Configures an IPv6 address for the switch
Configures IPv6 over IPv4 tunnels
Table 191: IPv4 Interface Commands
Command Group
Function
Configures the IP address for interfaces and the gateway router
Configures static, dynamic and proxy ARP service
Forwards UDP broadcast packets to a specified server