Configuring remote maintenance end points, Figure 274: configuring maintenance end points, Figure 275: showing maintenance end points – LevelOne GTL-2691 User Manual
Page 492: Configuring, Remote maintenance end points, Against the, Configuring remote maintenance end points" on, Configuring remote maintenance end, Points
C
HAPTER
14
| Basic Administration Protocols
Connectivity Fault Management
– 492 –
6.
Click Apply.
Figure 274: Configuring Maintenance End Points
To show the configured maintenance end points:
1.
Click Administration, CFM.
2.
Select Configure MEP from the Step list.
3.
Select Show from the Action list.
4.
Select an entry from MD Index and MA Index.
Figure 275: Showing Maintenance End Points
C
ONFIGURING
R
EMOTE
M
AINTENANCE
E
ND
P
OINTS
Use the Administration > CFM (Configure Remote MEP – Add) page to
specify remote maintenance end points (MEPs) set on other CFM-enabled
devices within a common MA. Remote MEPs can be added to a static list in
this manner to verify that each entry has been properly configured and is
operational. When cross-checking is enabled, the list of statically
configured remote MEPs is compared against the MEPs learned through
continuity check messages (CCMs), and any discrepancies reported via
SNMP traps.
CLI R
EFERENCES
◆