LevelOne GTL-2691 - Manual (Page 1220)

C HAPTER 42 | Multicast Filtering Commands
MLD Snooping
– 1220 –
ipv6 mld snooping
query-max-
response-time
This command configures the maximum response time advertised in MLD
general queries. Use the no form to restore the default.
S YNTAX
ipv6 mld snooping query-max-response-time seconds
no ipv6 mld snooping query-max-response-time
seconds - The maximum response time allowed for MLD general
queries. (Range: 5-25 seconds)
D EFAULT S ETTING
10 seconds
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
This command controls how long the host has to respond to an MLD Query
message before the switch deletes the group if it is the last member.
E XAMPLE
Console(config)#ipv6 mld snooping query-max-response-time seconds 15
Console(config)#
ipv6 mld snooping
robustness
This command configures the MLD Snooping robustness variable. Use the
no form to restore the default value.
S YNTAX
ipv6 mld snooping robustness value
no ipv6 mld snooping robustness
value - The number of the robustness variable. (Range: 2-10)
D EFAULT S ETTING
2
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
A port will be removed from the receiver list for a multicast service when
no MLD reports are detected in response to a number of MLD queries. The
robustness variable sets the number of queries on ports for which there is
no report.