LevelOne GTL-2691 User Manual
Page 119
C
HAPTER
3
| Using the Web Interface
Navigating the Web Browser Interface
– 119 –
Show Fault Notification Generator
Displays configuration settings for the fault notification generator
Show Continuity Check Error
Displays CFM continuity check errors logged on this device
IP
General
Routing Interface
Add Address
Configures an IP interface for a VLAN
Configure Interface
Submits a DHCP request for additional information from a VLAN
interface configured with a static IPv4 address
Show Address
Shows the IP interfaces assigned to a VLAN
Ping
Sends ICMP echo request packets to another node on the network
Trace Route
Shows the route packets take to the specified
destination
ARP
Address Resolution Protocol
Configure General
Sets the protocol timeout, and enables or disables proxy ARP for
the specified VLAN
Configure Static Address
Add
Statically maps a physical address to an IP address
Show
Shows the MAC to IP address static table
Show Information
Dynamic Address
Shows dynamically learned entries in the IP routing table
Other Address
Shows internal addresses used by the switch
Statistics
Shows statistics on ARP requests sent and received
Routing
Static Routes
Add
Configures static routing entries
Show
Shows static routing entries
Modify
Modifies the selected static routing entry
Routing Table
Show Information
Shows all routing entries, including local, static and dynamic
routes
Configure ECMP Number
Sets the maximum number of equal-cost paths to the same
destination that can be installed in the routing table
VRRP
Virtual Router Redundancy Protocol
Configure Group ID
Add
Adds a VRRP group identifier to a VLAN
Show
Shows the VRRP group identifier list
Add IP Address
Sets a virtual interface address for a VRRP group
Show IP Addresses
Shows the virtual interface address assigned to a VRRP group
Table 6: Switch Main Menu (Continued)
Menu
Description
Page