LevelOne GTL-2691 - Manual (Page 1579)

C HAPTER 50 | Multicast Routing Commands
PIM Multicast Routing
– 1579 –
ipv6 pim hello-
holdtime
This command configures the interval to wait for hello messages from a
neighboring PIM router before declaring it dead. Use the no form to restore
the default value.
S YNTAX
ipv6 pim hello-holdtime seconds
no ipv6 pim hello-interval
seconds - The hold time for PIM hello messages. (Range: 1-65535)
D EFAULT S ETTING
105 seconds
C OMMAND M ODE
Interface Configuration (VLAN)
C OMMAND U SAGE
The ip pim hello-holdtime should be greater than the value of ipv6 pim
hello-interval .
E XAMPLE
Console(config-if)#ipv6 pim hello-holdtime 210
Console(config-if)#
ipv6 pim hello-
interval
This command configures the frequency at which PIM hello messages are
transmitted. Use the no form to restore the default value.
S YNTAX
ipv6 pim hello-interval seconds
no pimv6 hello-interval
seconds - Interval between sending PIM hello messages.
(Range: 1-65535)
D EFAULT S ETTING
30 seconds
C OMMAND M ODE
Interface Configuration (VLAN)
C OMMAND U SAGE
Hello messages are sent to neighboring PIM routers from which this device
has received probes, and are used to verify whether or not these neighbors
are still active members of the multicast tree.