LevelOne GTL-2691 - Manual (Page 1223)

C HAPTER 42 | Multicast Filtering Commands
MLD Snooping
– 1223 –
port-channel channel-id (Range: 1-32)
D EFAULT S ETTING
No static multicast router ports are configured.
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
Depending on your network connections, MLD snooping may not always be
able to locate the MLD querier. Therefore, if the MLD querier is a known
multicast router/switch connected over the network to an interface (port or
trunk) on the switch, you can manually configure that interface to join all
the current multicast groups.
E XAMPLE
The following shows how to configure port 1 as a multicast router port within
VLAN 1:
Console(config)#ipv6 mld snooping vlan 1 mrouter ethernet 1/1
Console(config)#
ipv6 mld snooping
vlan static
This command adds a port to an IPv6 multicast group. Use the no form to
remove the port.
S YNTAX
[no] ipv6 mld snooping vlan vlan-id static ipv6-address interface
vlan - VLAN ID (Range: 1-4093)
ipv6-address - An IPv6 address of a multicast group.
(Format: X:X:X:X::X)
interface
ethernet unit/port
unit - Stack unit. (Range: 1-8)
port - Port number. (Range: 1-26)
port-channel channel-id (Range: 1-32)
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration