LevelOne GTL-2691 - Manual (Page 906)

C HAPTER 28 | Authentication Commands
802.1X Port Authentication
– 906 –
E XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout re-authperiod 300
Console(config-if)#
dot1x timeout supp-
timeout
This command sets the time that an interface on the switch waits for a
response to an EAP request from a client before re-transmitting an EAP
packet. Use the no form to reset to the default value.
S YNTAX
dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
seconds - The number of seconds. (Range: 1-65535)
D EFAULT
30 seconds
C OMMAND M ODE
Interface Configuration
C OMMAND U SAGE
This command sets the timeout for EAP-request frames other than EAP-
request/identity frames. If dot1x authentication is enabled on a port, the
switch will initiate authentication when the port link state comes up. It will
send an EAP-request/identity frame to the client to request its identity,
followed by one or more requests for authentication information. It may
also send other EAP-request frames to the client during an active
connection as required for reauthentication.
E XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout supp-timeout 300
Console(config-if)#
dot1x timeout tx-
period
This command sets the time that an interface on the switch waits during an
authentication session before re-transmitting an EAP packet. Use the no
form to reset to the default value.
S YNTAX
dot1x timeout tx-period seconds
no dot1x timeout tx-period
seconds - The number of seconds. (Range: 1-65535)