LevelOne GTL-2691 - Manual (Page 118)

C HAPTER 3 | Using the Web Interface
Navigating the Web Browser Interface
– 118 –
Configure Details Configures ring parameters 468
CFM Connectivity Fault Management 474
Configure Global Configures global settings, including administrative status, cross-
check start delay, link trace, and SNMP traps
477
Configure Interface Configures administrative status on an interface 481
Configure MD Configure Maintenance Domains 481
Add Defines a portion of the network for which connectivity faults can
be managed, identified by an MD index, maintenance level, and
the MIP creation method
481
Configure Details Configures the archive hold time and fault notification settings 481
Show Shows list of configured maintenance domains 481
Configure MA Configure Maintenance Associations 486
Add Defines a unique CFM service instance, identified by its parent MD,
the MA index, the VLAN assigned to the MA, and the MIP creation
method
486
Configure Details Configures detailed settings, including continuity check status and
interval level, cross-check status, and alarm indication signal
parameters
486
Show Shows list of configured maintenance associations 486
Configure MEP Configures Maintenance End Points 491
Add Configures MEPs at the domain boundary to provide management
access for each maintenance association
491
Show Shows list of configured maintenance end points 491
Configure Remote MEP Configures Remote Maintenance End Points 492
Add Configures a static list of remote MEPs for comparison against
the MEPs learned through continuity check messages 492
Show Shows list of configured remote maintenance end points 492
Transmit Link Trace Sends link trace messages to isolate connectivity faults by
tracing the path through a network to the designated target node 494
Transmit Loopback Sends loopback messages to isolate connectivity faults by
requesting a target node to echo the message back to the source
496
Transmit Delay Measure Sends periodic delay-measure requests to a specified MEP within a
maintenance association
498
Show Information
Show Local MEP Shows the MEPs configured on this device 500
Show Local MEP Details Displays detailed CFM information about a specified local MEP in
the continuity check database
501
Show Local MIP Shows the MIPs on this device discovered by the CFM protocol 503
Show Remote MEP Shows MEPs located on other devices which have been discovered
through continuity check messages, or statically configured in the
MEP database
504
Show Remote MEP Details Displays detailed CFM information about a specified remote MEP in
the continuity check database
505
Show Link Trace Cache Shows information about link trace operations launched from this
device
507
Table 6: Switch Main Menu (Continued)
Menu Description Page