LevelOne GTL-2691 - Manual (Page 1248)

C HAPTER 42 | Multicast Filtering Commands
MVR for IPv6
– 1248 –
mvr6 proxy-query-
interval
This command configures the interval at which the receiver port sends out
general queries. Use the no form to restore the default setting.
S YNTAX
mvr proxy-query-interval interval
no mvr proxy-query-interval
interval - The interval at which the receiver port sends out general
queries. (Range: 2-31744 seconds)
D EFAULT S ETTING
125 seconds
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
This command sets the general query interval at which active receiver
ports send out general queries. This interval is only effective when proxy
switching is enabled with the mvr6 proxy-switching command.
E XAMPLE
This example sets the proxy query interval for MVR proxy switching.
Console(config)#mvr profile rd 228.1.23.1 228.1.23.10
Console(config)#
mvr6 proxy-
switching
This command enables MVR proxy switching, where the source port acts as
a host, and the receiver port acts as an MVR router with querier service
enabled. Use the no form to disable this function.
S YNTAX
[no] mvr6 proxy-switching
D EFAULT S ETTING
Enabled
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ When MVR proxy-switching is enabled, an MVR source port serves as
the upstream or host interface, and the MVR receiver port serves as the
querier. The source port performs only the host portion of MVR by
sending summarized membership reports, and automatically disables
MVR router functions.