Table 40: configuration command modes – LevelOne GTL-2691 User Manual
Page 754
C
HAPTER
22
| Using the Command Line Interface
Entering Commands
– 754 –
◆
Line Configuration - These commands modify the console port and
Telnet configuration, and include command such as parity and
databits.
◆
Multiple Spanning Tree Configuration - These commands configure
settings for the selected multiple spanning tree instance.
◆
Policy Map Configuration - Creates a DiffServ policy map for multiple
interfaces.
◆
Router Configuration - These commands configure global settings for
unicast and multicast routing protocols.
◆
Time Range - Sets a time range for use by other functions, such as
Access Control Lists.
◆
VLAN Configuration - Includes the command to create VLAN groups.
To enter the Global Configuration mode, enter the command configure in
Privileged Exec mode. The system prompt will change to
“Console(config)#” which gives you access privilege to all Global
Configuration commands.
Console#configure
Console(config)#
To enter the other modes, at the configuration prompt type one of the
following commands. Use the exit or end command to return to the
Privileged Exec mode.
Table 40: Configuration Command Modes
Mode
Command
Prompt
Page
Access
Control List
access-list arp
access-list ip standard
access-list ip extended
access-list mac
access-list ipv6 standard
access-list ipv6 extended
Console(config-arp-acl)
Console(config-std-acl)
Console(config-ext-acl)
Console(config-mac-acl)
Console(config-std-ipv6-acl)
Console(config-ext-ipv6-acl)
CFM
ethernet cfm domain
Console(config-ether-cfm)
Class Map
class-map
Console(config-cmap)
DHCP
ip dhcp pool
Console(config-dhcp)
ERPS
erps domain
Console(config-erps)
Interface
interface {ethernet port |
port-channel id| vlan id}
Console(config-if)
Line
line {console | vty}
Console(config-line)
MSTP
spanning-tree mst-configuration
Console(config-mstp)
Policy Map
policy-map
Console(config-pmap)