LevelOne GTL-2691 User Manual
Page 757
C
HAPTER
22
| Using the Command Line Interface
CLI Command Groups
– 757 –
The access mode shown in the following tables is indicated by these
abbreviations:
ACL (Access Control List Configuration)
CM (Class Map Configuration)
DC (DHCP Server Configuration)
ERPS (Ethernet Ring Protection Switching Configuration)
GC (Global Configuration)
IC (Interface Configuration)
IPC (IGMP Profile Configuration)
LC (Line Configuration)
MST (Multiple Spanning Tree)
NE (Normal Exec)
PE (Privileged Exec)
Address Table
Configures the address table for filtering specified
addresses, displays current entries, clears the table, or
sets the aging time
Spanning Tree
Configures Spanning Tree settings for the switch
ERPS
Configures Ethernet Ring Protection Switching for
increased availability of Ethernet rings commonly used in
service provider networks
VLANs
Configures VLAN settings, and defines port membership
for VLAN groups; also enables or configures private
VLANs, protocol VLANs, voice VLANs, and QinQ tunneling
Class of Service
Sets port priority for untagged frames, selects strict
priority or weighted round robin, relative weight for each
priority queue, also sets priority for TCP/UDP traffic
types, IP precedence, and DSCP
Quality of Service
Configures Differentiated Services
Multicast Filtering
Configures IGMP multicast filtering, query, profile, and
proxy parameters; specifies ports attached to a multicast
router; also configures multicast VLAN registration, and
IPv6 MLD snooping
Link Layer Discovery
Protocol
Configures LLDP settings to enable information discovery
about neighbor devices
Connectivity Fault
Management
Configures connectivity monitoring using continuity
check messages, fault verification through loopback
messages, and fault isolation by examining end-to-end
connections between Provider Edge devices or between
Customer Edge devices
Domain Name Service
Configures DNS services.
Dynamic Host
Configuration Protocol
Configures DHCP client, relay and server functions
Router Redundancy
Configures router redundancy to create primary and
backup routers
IP Interface
Configures IP address for the switch interfaces; also
configures ARP parameters and static entries
IP Routing
Configures static and dynamic unicast routing
Multicast Routing
Configures multicast routing protocols PIM-DM and
PIM-SM
Table 42: Command Group Index (Continued)
Command Group
Description
Page