LevelOne GTL-2691 User Manual
Page 488
C
HAPTER
14
| Basic Administration Protocols
Connectivity Fault Management
– 488 –
◆
MIP Creation Type – Specifies the CFM protocol’s creation method for
maintenance intermediate points (MIPs) in this MA:
■
Default – MIPs can be created for this MA on any bridge port
through which the MA’s VID can pass.
■
Explicit – MIPs can be created for this MA only on bridge ports
through which the MA’s VID can pass, and only if a maintenance
end point (MEP) is created at some lower MA Level.
■
None – No MIP can be created for this MA.
Configuring Detailed Settings for a Maintenance Association
◆
MD Index – Domain index. (Range: 1-65535)
◆
MA Index – MA identifier. (Range: 0-4094)
◆
MA Name Format – Specifies the name format for the maintenance
association as IEEE 802.1ag character based, or ITU-T SG13/SG15
Y.1731 defined ICC-based format.
■
Character String – IEEE 802.1ag defined character string format.
This is an IETF RFC 2579 DisplayString.
■
ICC Based – ITU-T SG13/SG15 Y.1731 defined ICC based format.
◆
Interval Level – The delay between sending CCMs. The setting for this
parameter is expressed as levels 4 through 7, which in turn map to
specific intervals of time. (Options: 4 - 1 second, 5 - 10 seconds,
6 - 1 minute, 7 - 10 minutes)
◆
Connectivity Check – Enables transmission of CCMs.
(Default: Disabled)
◆
Cross Check – Enables cross-checking between a static list of MEPs
assigned to other devices within the same maintenance association and
the MEPs learned through CCMs.
Before starting the cross-check process, first configure the remote
MEPs that exist on other devices inside the maintenance association
using the Remote MEP List (see
"Configuring Remote Maintenance End
). These remote MEPs are used in the cross-check operation to
verify that all endpoints in the specified MA are operational.
The cross-check start delay, which sets the maximum delay this device
waits for a remote MEP to come up before starting the cross-check
operation, is a domain-level parameter. To set this parameter, use the
CFM MD Configuration screen (see
).
◆
AIS Status – Enables/disables suppression of the Alarm Indication
Signal (AIS). (Default: Disabled)
◆
AIS Period – Configures the period at which AIS is sent in an MA.
(Range: 1 or 60 seconds; Default: 1 second)