LevelOne GTL-2691 - Manual (Page 1575)

C HAPTER 50 | Multicast Routing Commands
PIM Multicast Routing
– 1575 –
show ip pim rp-hash This command displays the RP used for the specified multicast group, and
the RP that advertised the mapping.
S YNTAX
show ip pim rp-hash group-address
group-address - An IP multicast group address.
C OMMAND M ODE
Privileged Exec
E XAMPLE
This example displays the RP used for the specified group.
Console#show ip pim rp-hash 224.0.1.3
RP address : 192.168.0.2/32
Info source : 192.168.0.2/32, via (null)
Console#
IP V 6 PIM C OMMANDS
This section describes commands used to configure IPv6 PIM dynamic
multicast routing on the switch.
Table 232: show ip pim rp mapping - display description
Field Description
Groups
The multicast group address, mask length managed by the RP.
RP address
IP address of the RP used for the listed multicast group
Info source
RP that advertised the mapping, how the RP was selected (Static
or Bootstrap), and the priority used in the bidding process
Uptime
The time this RP has been up and running
Expire
The time before this entry will be removed
Table 233: show ip pim rp-hash - display description
Field Description
RP address
IP address of the RP used for the specified multicast group
Info source
RP that advertised the mapping, and how the RP was selected
Table 234: PIM-DM and PIM-SM Multicast Routing Commands
Command Function Mode
Shared Mode Commands
router pim6 Enables IPv6 PIM globally for the router GC
ipv6 pim Enables PIM-DM or PIM-SM on the specified interface IC
ipv6 pim hello-holdtime Sets the time to wait for hello messages from a
neighboring PIM router before declaring it dead
IC