LevelOne GTL-2691 - Manual (Page 1458)

C HAPTER 49 | IP Routing Commands
Routing Information Protocol (RIP)
– 1458 –
router rip This command enables Routing Information Protocol (RIP) routing for all IP
interfaces on the router. Use the no form to disable it.
S YNTAX
[no] router rip
C OMMAND M ODE
Global Configuration
D EFAULT S ETTING
Disabled
C OMMAND U SAGE
◆ RIP is used to specify how routers exchange routing table information.
◆ This command is also used to enter router configuration mode.
E XAMPLE
Console(config)#router rip
Console(config-router)#
R ELATED C OMMANDS
network (1462)
default-information
originate
This command generates a default external route into the local RIP
autonomous system. Use the no form to disable this feature.
S YNTAX
[no] default-information originate
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Router Configuration
C OMMAND U SAGE
This command sets a default route for every Layer 3 interface where RIP is
enabled. The response packet to external queries marks each active RIP
interface as a default router with the IP address 0.0.0.0.
E XAMPLE
Console(config-router)#default-information originate
Console(config-router)#