LevelOne GTL-2691 - Manual (Page 367)

C HAPTER 13 | Security Measures
Access Control Lists
– 367 –
Figure 189: Configuring a MAC ACL
C ONFIGURING AN ARP
ACL
Use the Security > ACL (Configure ACL - Add Rule - ARP) page to configure
ACLs based on ARP message addresses. ARP Inspection can then use these
ACLs to filter suspicious traffic (see "Configuring Global Settings for ARP
Inspection" on page 371 ).
CLI R EFERENCES
◆ "permit, deny (ARP ACL)" on page 992
◆ "show ip access-list" on page 979
◆ "Time Range" on page 817
P ARAMETERS
These parameters are displayed:
◆ Type – Selects the type of ACLs to show in the Name list.
◆ Name – Shows the names of ACLs matching the selected type.
◆ Action – An ACL can contain any combination of permit or deny rules.
◆ Packet Type – Indicates an ARP request, ARP response, or either type.
(Range: Request, Response, All; Default: Request)
◆ Source/Destination IP Address Type – Specifies the source or
destination IPv4 address. Use “Any” to include all possible addresses,
“Host” to specify a specific host address in the Address field, or “IP” to
specify a range of addresses with the Address and Mask fields.
(Options: Any, Host, IP; Default: Any)
◆ Source/Destination IP Address – Source or destination IP address.