LevelOne GTL-2691 - Manual (Page 1133)

C HAPTER 39 | VLAN Commands
Configuring Port-based Traffic Segmentation
– 1133 –
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ A port cannot be configured in both an uplink and downlink list.
◆ A port can only be assigned to one traffic-segmentation session.
◆ When specifying an uplink or downlink, a list of ports may be entered
by using a hyphen or comma in the port field. Note that lists are not
supported for the channel-id field.
◆ A downlink port can only communicate with an uplink port in the same
session. Therefore, if an uplink port is not configured for a session, the
assigned downlink ports will not be able to communicate with any other
ports.
◆ If a downlink port is not configured for the session, the assigned uplink
ports will operate as normal ports.
E XAMPLE
This example enables traffic segmentation, and then sets port 10 as the
uplink and ports 5-8 as downlinks.
Console(config)#traffic-segmentation
Console(config)#traffic-segmentation uplink ethernet 1/10
downlink ethernet 1/5-8
Console(config)#
traffic-segmentation
uplink-to-uplink
This command specifies whether or not traffic can be forwarded between
uplink ports assigned to different client sessions. Use the no form to
restore the default.
S YNTAX
[no] traffic-segmentation uplink-to-uplink {blocking |
forwarding}
blocking – Blocks traffic between uplink ports assigned to different
sessions.
forwarding – Forwards traffic between uplink ports assigned to
different sessions.
D EFAULT S ETTING
Blocking
C OMMAND M ODE
Global Configuration