LevelOne GTL-2691 - Manual (Page 1206)

C HAPTER 42 | Multicast Filtering Commands
Static Multicast Routing
– 1206 –
S TATIC M ULTICAST R OUTING
This section describes commands used to configure static multicast routing on the
switch.
ip igmp snooping
vlan mrouter
This command statically configures a (Layer 2) multicast router port on the
specified VLAN. Use the no form to remove the configuration.
S YNTAX
[no] ip igmp snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4093)
interface
ethernet unit/port
unit - Stack unit. (Range: 1-8)
port - Port number. (Range: 1-26)
port-channel channel-id (Range: 1-32)
D EFAULT S ETTING
No static multicast router ports are configured.
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ Depending on your network connections, IGMP snooping may not
always be able to locate the IGMP querier. Therefore, if the IGMP
querier is a known multicast router or switch connected over the
network to an interface (port or trunk) on this switch, that interface can
be manually configured to join all the current multicast groups.
◆ IGMP Snooping must be enabled globally on the switch (using the ip
igmp snooping command) before a multicast router port can take
effect.
Table 144: Static Multicast Interface Commands
Command Function Mode
ip igmp snooping vlan
mrouter
Adds a multicast router port GC
show ip igmp snooping
mrouter
Shows multicast router ports PE