LevelOne GTL-2691 - Manual (Page 1290)

C HAPTER 43 | LLDP Commands
– 1290 –
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
When LLDP is re-initialized on a port, all information in the remote systems
LLDP MIB associated with this port is deleted.
E XAMPLE
Console(config)#lldp reinit-delay 10
Console(config)#
lldp tx-delay This command configures a delay between the successive transmission of
advertisements initiated by a change in local LLDP MIB variables. Use the
no form to restore the default setting.
S YNTAX
lldp tx -delay seconds
no lldp tx -delay
seconds - Specifies the transmit delay. (Range: 1 - 8192 seconds)
D EFAULT S ETTING
2 seconds
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ The transmit delay is used to prevent a series of successive LLDP
transmissions during a short period of rapid changes in local LLDP MIB
objects, and to increase the probability that multiple, rather than single
changes, are reported in each transmission.
◆ This attribute must comply with the following rule:
(4 * tx-delay) ≤
refresh-interval
E XAMPLE
Console(config)#lldp tx-delay 10
Console(config)#